About h.dam

h.dam · 04-12-2022

Hello all, I have a pair of FTD 2130 with A/P. They both have different mgmt IP address.Last week I got peer failed error so I tried to connect them via console port. I realized that I cannot connect to Standby device via console port while I can use...

h.dam · 02-24-2022

Hello,I'd like to know if it is possible to create a read only user account to access FTD 2130 using FDM (I don't use FMC)I have tried to create a user by CLI: config user add xxx basicThis user account can only access the device via SSH but came out...

h.dam · 02-24-2022

Hello all,We have a FTD A/P pair registered after purchase. They are working well until last month. They have lost the licenses without reason and became unregistered.This is the first time I met after more than ten years pratices on Cisco devices.I'...

h.dam · 09-02-2021

Hello,I have tested the FPR 2100 HA pair switching time in lab, it took 10 sec.For our production environment, it is too long.I remember that ASA 55xx A/S switching is immediately. Do you have the same time?Maybe there are some specific settings for ...

h.dam · 08-10-2021

Hello,I configured a pair of FTD 2130 as active/passive but they didn't synchronise and gave "peer failed" error.The "show failover state" showed there are monitored interfaces "no link" error.These interfaces on FTD are configured using Ethernet cha...

h.dam · 04-14-2022

Hello Marvin, I made a power on/off on this Standby device while connecting the console port, nothing happened. So I think I should contact Cisco for a RMA.Thanks very much.

h.dam · 02-28-2022

OK.Thank you Rob.

h.dam · 02-25-2022

OKThank you very much. Regards

h.dam · 02-24-2022

Yes, I know Radius is a solutionBut I'd like to use local user because it is more simple and doesn't need additional config.What I want is using this local user account (with basic rights without enable access) to view the policies but has no rights ...

h.dam · 02-24-2022

Hello Marvin,Thank you very much for the document.My FTDs are v7.0.1.But I didn't find this version in the document.As I understood, there are two solutions. 1/ software upgrade 2/ import the IdenTrust Commercial CA certificateIn my case, which solut...

Member Since	‎12-14-2001 08:26 AM
Date Last Visited	‎06-13-2022 01:27 AM
Posts	152
Total Helpful Votes Received	86

User Statistics

User Activity

FTD console port cannot access

Read only user account to access FTD device using FDM

Is unregistered FTD still functional?

FTD HA active/standby switching too long

FTD failover peer failed

Re: FTD console port cannot access

Re: Read only user account to access FTD device using FDM

Re: Is unregistered FTD still functional?

Re: Read only user account to access FTD device using FDM

Re: Is unregistered FTD still functional?