Colin,If you have an ML1000 card that fails, you only need to replace that card with another ML1000 in the same slot. The ML config will be downloaded from the TCC card. If you wanted to move the ML1000 card to another slot, you would need to have a ...
Tom,Good document. It is good to see all of that information in one location. I don't think that you have this link listed, but you might consider adding it. http://www.cisco.com/en/US/prod/collateral/optical/ps5724/ps2006/brochure_c02-452560.htmlTha...
Phil,If you haven't reset the TCC card and gotten this to work, I think the best route to take would be to open a TAC case with the Optical group to look at this. It would be much easier via webex.Rex
The SONET STS tab doesn't have anything to do with adding a circuit. That tab will show up once you are finally able to create an STS1 circuit in the third timeslot.When you go to build the circuit, STS#3 is not an option correct? If there are no cir...
Curt,When going to the Edit circuit screen are you looking at the detailed map by checking on the box at the bottom of the Edit circuit screen?If you are looking at the non-detailed map of the circuit, you will see green links all the way around the ...
