About imanco671

imanco671 · 12-18-2012

Hello,I am using a Cisco ASA 5505Here is a description of my topology.Headquarters = 192.168.201.0Client X = 172.16.0.0Datacenter = 10.12.0.0Site to Site Tunnels:Headquarters ---> DatacenterDatacenter ---> Client XI want to ability for computers in t...

imanco671 · 11-30-2011

Hello Community,I just joined a new company and want do not understand why internal users cannot access an outside FTP site.I can establish a connection but it will not list the directories.I have tested other FTP sites to connect to and all works fi...

imanco671 · 11-16-2011

Hello Community,I have been researching a way to remove this subnetted route from my L3.There is an extra subnetted route that should not be there when I execute the command: show ip routeBelow if part of my Show Run and the Show IP Route commands. Y...

imanco671 · 11-15-2011

Hello Community,I would like to properly configure my L3 to support iSCSi traffic.My L3 acts as an internal router between 4 different subnets.I have a iSCSi SAN on my network. A Windows server has Microsoft iSCSi initiators connecting to the SAN.Tha...

imanco671 · 11-11-2011

Hello Community,I have recently tried implementing a Catalyst L3 into my network acting as an internal router between 4 subnets.Once I implmeneted, I noticed that there were lots of packet latency and dropped packets. I was losing connections to serv...

imanco671 · 12-19-2012

Hi Jennifer, thanks for the reply,So is there a possibility if I add the 172.16.0.0 subnet to the tunnel on each end?Right now the HQ tunnel to Datacenter has local of 192.168.201.0/24 and remote of 10.12.200.0/24I would need to add the remote of 172...

imanco671 · 11-30-2011

Hi Rick,It hangs and still says "150 Here comes the directory listing."I am trying to connect to the Amazon cloud, I know they only allow passive connections.Could it be not having a ACL in the proper place?I have also found these other ACLs:access-l...

imanco671 · 11-30-2011

Hi RIck,Yes it it quite strange and thank-you for not bailing on me.I can change the directoy, but then I try to do a LS command, then it just hangs. It also says to consider using PASV, which I have tried but no success.Here is my DOS FTP commands:C...

imanco671 · 11-30-2011

Hi Rick,Thanks for the quick response.Yes the access list outbound is small and there are only permits.Well it is strange, I am able to access other FTP sites via DOs or filezilla. This particular FTP does not allow to access directories. but it does...

imanco671 · 11-17-2011

How can I remove that extra subnetted route?I tried using the command, but was unsuccessful: no ip route 10.0.0.0/24

Member Since	‎08-03-2011 06:25 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	220
Total Helpful Votes Received	5

User Statistics

User Activity

Static routes through site-to-site tunnel

FTP not working from Internal Network

How to remove subnetted route on Catalyst 3560

Catalyst 3560 optimize for iSCSi traffic

Packet Loss on Catalyst

Static routes through site-to-site tunnel

Re: FTP not working from Internal Network

FTP not working from Internal Network

FTP not working from Internal Network

How to remove subnetted route on Catalyst 3560