,Hi, I have HQ router as NTP server. Pub points to router for NTP refrence.For others, Sub, Unity, Presence, etc. Which one should I use as time server?Thanks.
Hi,If a router has multiple voice-port (multiple PRI), do I need to confiure incoming dial-peer for all or just single with no voice-port command is enough?Thanks,
Hi,How ringing and ring-back audios play in voip using skinny and sip protocols?In other words, who is responsible for ringing/ring-back tone: ip phone/local gateway/call agent?Thanks,
p.bevilacqua wrote:mpaneers wrote:Hi adilTry this for your inbound and outbound dial-peer as per your requirement.For your Inbound to PotsIncoming called Number is 0752, dial peer 1111 should match. Try this simple config in your test routers and app...
Thanks. I will try.I assume this would allow users to navigate other pages (such as config)?I just want others to see dash board, monitor (top attackers etc) only.Anyway exported via RSS or similar?
utils ntp status is synchronized to local stratum 11.didn't see ntp server (router) under remote column. there was local address onlyutils ntp config says syncronized to it hardware clock.thanks