Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
ssh enabled, but telnet service still on when doing "telnet 10.4.255.1 23" . Not sure why it is so, I presume it is because of line vty 5 15 below ? Need some advice on this. Thanks.
------------------------------
line con 0exec-timeout 5 0 login...
Hi
I have an international circuit and found that the TCP output drop has consistently increased bit by bit. (Screenshot as attached). I have checked layer 1 is fine, what could be the issue besides this?
Thanks.
ken
Hi
Currently my users are having some issues on slowness when connecting to the server. I did a sniff and attached is the traffic.
It is saying that the server IP is performing a TCP Retransmission to the client. Can I know is this means that the se...
Hi
I would like to check if TX an RX did corresponde to the Traffic In and Traffic out of a Total Bandwitdh.
Example, I have a MPLS 50Mbps link, found out that the Traffic In is 28Mbps and Traffic out is 38Mpbs. Can I assume that these 2 traffic ha...
Hi
I have tried to perform a debug client <MAC address> on WLC5508 but there isn't any output even though I restart the process of laptop client connecting to the wireless SSID.
I am trying to troubleshoot an issue on "Limited Access" as found from ...
Hi Sohan
Thanks again for your reply. I have the graph BW as attached, but from your expertise, do you think this is over-subscribed with the traffic in and out given in the graph?
Regards,
hi Sohan
Thanks, but we are not using QoS from the router side. So can I say that this is the only way to check for the traffic if it is being dropped by over-utilisation?
Thanks.
Hi Sohan
Thanks for your input post. As I checked from the bandwitdh, it is within the max bandwidth , any where I can confirm this be it in the command used in the router or other places..?
p/s: btw the Bandwitdh is 50Mbps.
Thanks.
