We have WCS installed on a windows server and lately have noticed that WCS service stops all of a sudden without any intervention and needs a manual restart thereafter.Is it common or a bug that's causing it or hw can it be addressed ?thanks:}
How to monitor Cisco 6500 Native IOS Sw 12.2(18)SXF7 backplane that has all virtual etherchannels for almost each module like CSM, FWSM, WiSM,IDSM etc.
Is it possible to configure NetFlow on L2 gig switchport on a multilayer switch running native IOS ?How else can it be done and what tool can be used to view traffic visibility as seen via Netflow
Amit,interface policy is set to 50% i.e if any one interface goes down...FWSM failover should triggger.when the RTR1 goes down, say, we reboot it..FWSM context outside interface does not go down ..dont know why...and we are therefore forced to manual...
Thanks for the response Amit.As i mentioned each FWSM mod has 2 contexts, X and Y.Each context has it's own inside and outiside interface and context Y has a DMZ interface as well.As part of failover configuration, i have configured following command...
Than you Amit for the response.For the 4th question - regarding automatic FWSM failover, i think, i did not put the question correctly, i will diagram it for u.SiteA SiteB CoreSW1----CoreSW2------L2-----CoreSW3 ...
Amit,Thanks for the response.Is it possible to setup the 2 contexts to have 2 separate inside interfaces but a single common external interface? How?you said, yes...it's possible. 1. What happens if the shared interface switchport is down? Will whole...
