Hi All,I would like to try to implement T37 S&F on a 2951. However, my PRI is already binded to an MGCP gateway to CUCM, which means the dial plan will be ignored on any incoming calls, so I can't get the call to the onramp script. Is there a way to ...

Does this make any sense? My core switch (acting as the default L3 for clients) is responding to all arp requests with one of it's own MAC addresses. I can't figure out why. Any ideas?Thanks

Hey guys,Somewhat new to CME. Spec'ing out a small system for 20 phones running off a 2911. I want the 2911 to handle all of the calls, voicemails, basic AA, and do basic IOS firewall for the facility. Phones will be 7942's, and I'm planning on using...

Hey guys,Putting in a 1Gbps private ethernet link between 2 sites. Currently have 2 2811's at each location, don't think that will cut it. I was going to get 2 2911's, but looking at the docs it looks like they can only do 180mbps of throughput? Am I...

Hey guys,I need to implement a VPN backup for an MPLS network (running ibgp). I would like to concurrently run a VPN tunnel from a branch office to HQ alongside a MPLS. When the MPLS goes down I'd like traffic to go over the VPN, but only then. I was...