Hello everyone,
i have installed Cisco 9800-CL virtual WLC on vmWare ESXi.
current setup lools like :
WLC has dedicated MGMT interface(GIG1) and trunk port (GIG2).Cisco VPC is configured with ESXi standard switch, with active passive uplink ports....
Hello, can someone tell me the performance of 900 series routers, datasheet tells only encryption performance? i wonder just NAT throughput without any encryption
Hello,i am planing to purchase 9800 virtual wireless controller with 100 x AIR-AP1815I-E-K9. questions are following : 1) can i go with legacy licensing model with AP adder licenses ?2) if there is only AIR-DNA licenses, what will happen if subscript...
Hello everyone,
we are preparing the demo environment for our customer. configured web authentication with LDAP integration. everything is working normally, but have following question regarding Excessive Web Authentication Failures :
1) can we cont...
hi @Rich R ,
you are right from hypervisor it is not possible to restrict VLANs on trunk port, unless it is vmware distributed switch. i had standard switch and configured as you described. at this moment everything is ok.
Hello @Rich R ,
we did not have same VLAN on both interfaces, GIG1 had MGMT VLAN and GIG2 all SSID VLANs(exept that MGMT). and this type of config has produced strange traffic loads on bith interfaces.
now it is ok, we just have all nessesary VLANs...
Hello Everyone,
we fount the issue. here is the description :
in our initial configuration we have used GIG1 for wireless management and GIG2 for data plane trunk. controll plane traffic must to GIG1 and data plane to GIG2. but in reality we were s...
Maybe we need to move WMI from GIG1 to GIG2 , GIG2 is trunk interface. From the best practice docs, I see that GIG1 is for OOB and WMI should be tagged inside GIG2 Trunk, where WMI and Client VLANs will be tagged
