Also the same data sheet referenced by original poster reflects the channel widths/etc showing 2.4GHz doesn't include 40MHz.  While it does show that there is a 300Mbps maximum PHY rate (which is true); it's under particular configurations/circumstan...

Making it easy on him eh?  Good call Scott.

You cannot configure channel bond on 2.4GHz; this is explained in the document linked via the answer marked "correct" and is in quotations below.  I suppose it's feasible his AP is running a much older IOS release, but it looks like a 12.4 releaseTem...

While a bit cumbersome; it's feasible.  It would require some legwork and post-collection formatting.  From the CLI...To see list of AP names and IPs you could perform >show dtls connectionsAny AP that has CAPWAP control path up (joined to WLC) would...