We are planning to implement the 6509-E with two Sup 2Ts and a few 48 ports switches. We also want to make this the router for our network and replace the 7206VRX.Any advise on this would be helpful.Thanks in advance!
I don't have that configuration in place now since the stack and router are in production.I tried a few things last night and the Po interface never showed up but down (not connected all the time), the physical interfaces on the switches show suspen...
Thanks for the quick response.So do I need to configure Layer 3 ports on the cross-stack switch?int g1/0/22 no switchportint g2/0/22 no switchportint po22 no switchportint g1/0/22 channel-group 22 mode onint g2/0/22 channel-group 22 mode on And on th...
I have a similar problem.Cisco router 2851 connecting to a stack pair 3750x.The port channel doesn't form or stay up. It said LACP is not supported on remote port (the remote port being the 2851). Cisco doc shows that the built in Gig interfaces do s...
I have similar configuration, with two different ISPs. Each connecting to a single router. These two routers have EIGRP full mesh and redistribute.BGP is configured on both routers, to their respective ISP. I have configured higher local preference o...
I am having similar design requirements, except I don't know how to go about all of this.We have two data centers, both of them are active. Each site has one ISP, and the ISPs are from different provider. The two sites have a WAN connection in betwee...