I'm looking to setup a cli push from Prime for individual ports. I want to look to see what vlan and voice vlan is on that interface and take those numbers as variables and then push config to that interface based on what those variables say.
I have a cluster that I want to manage the individual ASA's for different things how do I connect to an individual ASA other than using the serial port? IE can i have a management ip on each ASA and then the cluster management IP as well.
I'm looking to see how the F3 cards are broken up into port groups or if they are line rate per port. I'm not finding any documentation to dictate either way. On the other cards when assigning them to a VDC you have to assign them based on port gro...
Hello, I have a problem with caller id comming in and showing the contact id on my phones instead of the phone number. Is there a way to remove the caller contact info or replace it with the calling number using a sip profile on my router?Patrick
Hi,I have two HWIC-4T1/E1 in two 2821's I can not for the life of me find software so I can configure them in the routers. I see them in the inventory but don't see them in show ver. I'm assuming that the software is not recognizing them. I've tr...
Well Hell just figured it out its sitting right there in the config telling me to post the card type. typed into the configuration "Card type t1 0 0" and it works yeah.LOL
You should be able to pop open the Lid look at the existing memory go to kingstons website and compare that memory usings kingstons tools/memory guide to get the appropriate memory that way.
