Hi,
Need to deploy ACI solution, for which I have consider 9336C-FX2 as Spine switch and 93108YC-FX switch as leaf switch in ACI mode.
Need to know whether I can use 9336C-FX2 as Spine switch.
Regards
Navneet
Hi, Need to know what will be the forwarding capacity in Kpps of Cisco841M-4X router at 64 bytes. Also if any public document available, pls share the link Thanks Navneet
Hi,
Iam configuring new ISR4451 router along with SM-X-ES3-16-P service module in CCW. I believe SM-X-ES3-16-P comes with LAN base image which can support static routing. For Layer 3 functionality (RIP etc) , I need to purchase minimum IP Base licens...
Hi,
I have Radware Load Balancer having 40Gig QSFP+ (MPO connector) at one end and Cisco Nexus 9372 switch with 10Gig SFP+ (LC connector) at other end.
Iam using 40Gig to 4xLC Fanout cable for connecting Radware Load Balancer with Cisco Switch.
My ...
Hi, As per the performance guide, 890 support 100 kpps of forwarding rate at 64 bytes so it means 840M will support 100kpps or less forwarding rate at 64 bytes. I hope my understanding is corrrect.
I have not purchase the IP base License , need to purchase it but it is showing End o f sale, pls suggest which part code I need to consider for IP base license.
Thanks
Navneet
Thanks Reza.
Most of the cases, it is 40Gig on Switch end which split it in 4x10Gig ports on other side. But in my case it is opposite, Radware end it is 40Gig which need to split to 4x10Gig ports at switch end, so I need to configure the interface...
