About kondratev

kondratev · 03-13-2011

Hello!I have a simplest FR network: 2 routers are connected through FR-switch. Configs are below:aaaFR-switch:frame-relay switchinginterface Serial0/0 description Router 1 no ip address encapsulation frame-relay no keepalive clock rate 2000000 frame-...

kondratev · 03-07-2011

Hello,I have a simple network (see attachements). On R3 I have a route 10.10.10.0/24 from two sources: 1.1.1.1 and 2.2.2.2. R3 need to choose the route from 1.1.1.1. And I must do it with administrative distance for some reason. I can't change any OS...

kondratev · 02-20-2011

Hello,I need to monitor 5 minute CPU utilization with EEM. I don't know what I need to specify in the field 'taskname' in the command 'event ioswdsysmon sub1 cpu-proc ...'? May be I need to specify 'taskname cpmCPUTotal5minRev'? I'm unsure about it.C...

kondratev · 02-19-2011

Hello, Am I correctly understand that 2 commands shape peak 64000 and shape average 128000 have the same meaning? Do anybody know for what purpose Cisco implemented Peak Shaping?

kondratev · 02-17-2011

Hello,I need to configure my router to be RP for 1 group only. It should reject PIM messages for all other groups. I've tried to to the following:ipv6 pim rp-address XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX ALLOWED_GROUP!ipv6 access-list ALLOWED_GROUP...

kondratev · 03-07-2011

But if I input the command 'dstance 255 2.2.2.2 0.0.0.0 NET', AD influences Path selection. Or it's a bug also?I have IOS 12.2(53)SE2. So there is no such bug in it.

kondratev · 02-28-2011

Hello Steve,No, I haven't actual traffic. If I understand you correctly, I can't see my configured active probes in the output of 'show oer master active-probes' before traffic is transmitted. Is it true?

kondratev · 02-20-2011

Thank you, Peter!You explanation is very clear!

kondratev · 02-20-2011

I tried this configuration:event manager applet CPU event snmp oid "1.3.6.1.4.1.9.9.109.1.1.1.1.8" get-type exact entry-op gt entry-val "60" entry-type value poll-interval 60 But when I activate 'debug event manager detector snmp', I see the followin...

kondratev · 02-20-2011

Hello Peter,Your solution is good! My router isn't dhcp client itsef, but I can make it to be dhcp client on one of its interfaces artificially (to get correct DHCP options from its neighbor). And then I can use the command 'import all' with each DHC...

Member Since	‎02-22-2007 01:41 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	49

User Statistics

User Activity

Simplest Frame Relay doesn't work

OSPF Distance

Embedded Event Manager - IOS Watchdog System Monitor

Peak vs Average Shaping

IPv6 PIM RP for one group only

Re: OSPF Distance

Re: OER Configured Active Probes

Re: Peak vs Average Shaping

Re: Embedded Event Manager - IOS Watchdog System Monitor

Re: DHCP Options