About minfonet

minfonet · 07-28-2010

Hi all,I'm using CUCM 7.1.3 and 2811 with FXO port as MGCP gateway. Each user is using softphone. When there is incoming call to softphone, the user complain that the sound is small. I've tried to increase the volume of softphone to maximum and incre...

minfonet · 07-26-2010

Hi all,I'm implementing CUCM in a customer, their segment ip address is rather weird which is 169.254.0.0/16. I cannot ping that segmet from CUCM and if i traceroute the packet is bound back to CUCM.It is hard to change the segment ip address because...

minfonet · 07-15-2010

Dear allI'm running CCX 7.0 and supervisor has a feature to listen to agent's talking (voice monitor). When the supervisor start voice monitor, sometimes there is delay. And sometimes the supervisor cannot start voice monitor because suddenly the age...

minfonet · 07-14-2010

Hi all,I'm experiencing a problem with CM 7.1.3. When incoming call through FXO port in MGCP gateway is hang up by the caller, status of softphone is still connected. The softphone user hear disconnect tone and i checked the MGCP gateway using show v...

minfonet · 07-28-2010

Hi Jonathan!Thank you for your answer. It's work.

minfonet · 07-18-2010

Hi the_qamarThank you for your advice. How about the delay in voice monitor result? If supervisor start voice monitor, there is delay when supervisor hear his agent's conversation. Do you have any idea?Thanks.

minfonet · 11-15-2006

Recently i just experienced this issue, we got an IP address change and must change the site-to-site peer. i use "no" to all our crypto map commands and acl, then enable that again. But then i must restarted the pix to get it to the right peer.

minfonet · 11-15-2006

Dear Arul,Then if we have PIX with 6.3 version, is that some way we can do that?How if we have the different interface for remote access and site to site (eth0 for remote access and eth1 for site-to-site)?

minfonet · 01-08-2006

hi vince, if you're not having voip between fxo to fxo then you can prefer "thotsaphon" configuration to set timeout at you're voice-port. for me it if it isn't fxo to fxo then it's ok.the problem occurs when there is voice connection between fxo voi...

Member Since	‎08-26-2005 12:27 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	11

User Statistics

User Activity

how make sound of a call louder?

Cannot ping segment 169.254.0.0/16 from CUCM

Delay in voice monitoring

Disconnected call issue

Re: how make sound of a call louder?

Re: Delay in voice monitoring

Re: VPN IP errors

Re: Vpn clients can not access sites that are over a site to sit

Re: FXO to FXO disconnection problem -- Help me please.