I am trying to use the USB0 and USB1 in a 5508 WLC. I have formatted my flash drive for FAT and FAT32 without success. I want to transfer some files over, is this possible using the USB ports in the front of the controller?
Just a questions on this. This seems simple but doesn't make sense to me. I have seen engineers who have an IP of 192.168.100.1/26 for an SVI address. My question is if you are going to use a /26 why would you use .1 as your SVI IP? Shouldn't you use...
We currently have 2 ISP. I am peered to one using BGP. I would like to have a way if our primary ISP is down that external users can access our outside facing servers with the public block of IP that we have. What type of resources would I need on my...
I am moving from the 3750 series to the 3850 series and wanted to know if I need to use the mgmt-vrf port. From what I have read it is the out of band port and I use the vrf port on some of our Nexus switches so I am familiar but would you use that m...
I need to route traffic that is sourced from 10.1.50.0 network down link 1. Currently all traffic goes down Link 2. I want all traffic except 10.1.50.0 network to still use Link 2 as primary. What would be the best approach a static route for the 10....
Thanks for your reply. Is there any Cisco documentation on this? I have looked but very limited info. Also if not supported what are those USB ports used for?
Would that be the first address because the address is a class C and should be a /24 and since we are moving over the bits to a /26 the 192.168.100.0 would be covered under this?
VLAN 10
192.168.100.1 255.255.255.192 is the SVI for VLAN10
Should I s...
I ran into this problem yesterday. Yes you need to make sure you have disk space, install the mandatory patch and run the database-compress. It turns out that a co-worker was downloading the update using a mac and Safari was doing something to the fi...
Thanks Mark. Since the vrf port is ethernet I would have to have a way to get it to connect back to a central device or other switch? Would there be a down side on using Vlan1 if I cant use vrf? Thanks
Thanks for the reply. I created the access list and policy map from above but can not put the policy map on the VLAN interface. The commands are there but when I verify by looking at the interface it is not there. It is a 3750 G with IPSERVICES IOS. ...
