bill.morton
Level 1
Level 1
Member since ‎05-02-2006
‎08-18-2017

User Statistics

  • 66 Posts
  • 0 Solutions
  • 30 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Helpful Vote
10 Replies
5 Replies
20 Replies

User Activity

I am working with a 4400 controller and 1020 APs and I am trying to add a new WLAN to migrate old devices onto a new security/auth. The problem that I am running into is that when the WLAN is enabled, 15 of the 20 APs start rebooting constantly with ...
I am trying to kill off some NETBIOS traffic within a VLAN with a VLAN filter map so it dosn't keep filling up my logs when it fails against the inbound ACL on the VLAN interface but it is not working as I expect it to (and my other VLAN filter maps ...
If I have two VLANs, 1 (native) and 2 (iSCSI) and I want to put inbound ACLs to restrict the traffic that gets into VLAN 2. From the perspective of VLAN 2, does my inbound ACL get evaluated for both traffic originating from VLAN 1 and going into VLAN...
I need to allow for good traffic into my vmware environment but block bad broadcast and multicast traffic from getting in. Currently I have an SVI setup to allow for the communication but it seems to allow broadcast and multicast traffic to get to my...
Since implementing QoS on a T1 link it seems that the utilization has dropped ... a lot, and I need a quick review to make sure I didn't fat-finger or do something dumb (it happens). The interface is a full T1 (private point-to-point), which should b...
Community Statistics
Member Since ‎05-02-2006 12:43 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 66