About kevin.crookes

kevin.crookes · 07-13-2011

Morning All,I am about to start installing two new (and very nice) Cisco 2960-S switches into a network as explained below:6 - Servers10 - Network Printers10 - Wireless access Points1 - WatchGuard Firewall (x750e)80 - 120 client PC's and Devices.Curr...

kevin.crookes · 06-14-2011

Hi Everyone,I have got an interesting problem with some Samsung POE IP Phones (ITP-5114D). If I plug one of them into the C3550 switch, the port comes up for about 2/3 seconds and then goes down, and the switch does this until I either shutdown the p...

kevin.crookes · 05-27-2011

Hi,I'm in the process of looking to purchase three new 48 port 10/100/1000 switches. These will be connected via GBIC's in a hub and spoke configuration (ideally), all located in the same cabinet.Switch1 - Being the hub and having all 8 servers conne...

kevin.crookes · 07-13-2011

Thanks for the information Marcin.We didn't have enough money in our budget to go for the L3 switches as we needed gigabit across all ports, so we went for the 2960-S. At our other site we have the older 3550's which run perfectly, just a shame I co...

kevin.crookes · 06-15-2011

As far as I am aware the switch is running the latest version of the IOS. If someone could confirm that it would be great.I will see if I can find these in the UK although it might start to get a little costly as we will have 20 of these shortly.

kevin.crookes · 06-15-2011

Just for some further information. I have managed to get the POE Status from the current 3COM switch which they are plugged into.Unit: 1Compatible mode : EnabledInterface Admin Oper Power(mWatt) Power(used) Priority High Power---------- -------...

kevin.crookes · 06-15-2011

Hi,Ok, I have pasted the debug information below:EXHXSW2#Jun 15 08:06:57.366: ILP uses Link Disconnect(Fa0/13): state= ILP_DETECTING_S, event= TWTI_PWR_GOOD_EVJun 15 08:06:57.366: Ilpower PD device 2 class 9 from interface (Fa0/13)Jun 15 08:06:57.36...

kevin.crookes · 06-14-2011

I am currently off site at the moment but will post the debug information tomorrow morning. Thank you for the suggestion.

Member Since	‎11-17-2010 07:27 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	12

User Statistics

User Activity

IP Ranges

Problem with Cisco C3550 Switch (Inline Power)

Which Cisco Switch/Router and VLAN Planning...

IP Ranges

Problem with Cisco C3550 Switch (Inline Power)

Re: Problem with Cisco C3550 Switch (Inline Power)

Problem with Cisco C3550 Switch (Inline Power)

Problem with Cisco C3550 Switch (Inline Power)