About benharned

benharned · 07-15-2011

Thanks for the reply but when I go issue the 'speed 1000' command cli says it's invalid.

benharned · 07-15-2011

I know with a ASA5510-SEC-BUN-K9, you can increase eth0/0 and eth0/1 to gigabit with the right IOS. ...

benharned · 01-27-2010

That did it. Thanks!! (knew it was simple!)**********The information contained in this email and any...

benharned · 01-27-2010

CCM 4.2(3)Have a number of new 7921G phones replacing our 7920 devices. Users love them but our rece...

benharned · 12-17-2009

I have some 7920 devices that I will be replacing eventually (one immediately) with 7921G devices. C...

benharned · 10-27-2009

Any resolution to this? I am experiencing the same thing and wish calls to return to the parker.

benharned · 08-18-2009

I too have been lax on patching my servers. Can I just install the latest Cisco patches, or do I nee...

benharned · 08-17-2009

Anyone? Anything?Bump.

benharned · 08-12-2009

ASA 8.2(1)ASDM 6.2(1)I'm not the most versed in CLI so I am not totally sure of the right commands. ...

benharned · 08-12-2009

Thanks for the link. Ran it, all good.Well formed: VALIDSchema validation: VALIDNow what? Is there a...

benharned · 08-12-2009

Following the steps in:http://www.cisco.com/en/US/products/ps6120/products_configuration_example0918...

benharned · 07-29-2009

Thanks for the info. That doesn't seem a severe trade-off. Who really has low BW anymore anyway? Unr...

benharned · 07-28-2009

I somehow missed this reply. I unchecked the "optimize..." option and calls are now being connected ...

benharned · 06-22-2009

Sorry, that would help, eh?CCM 4.2(3)CIPC 2.1.4

benharned · 06-22-2009

Thank you, but yes. :(

Date Registered	‎08-19-2005 12:23 PM
Date Last Visited	‎08-18-2017 03:55 AM
Total Messages Posted	118
Total Helpful Votes Received	5

Gigabit Interfaces in ASA5510-CSC10-K9 ?