You can change it to desktop routing instead of desktop default.conf tsdm prefer routingendwrreloadMake sure you reload or the change won't take affect. Kathy
Rick is right, in later code with EIGRP NSF enhancements the neighbor won't flap. It will only resync. I verified with a quick test on my lab device.R15(config)#do sh ip eigrp neighEIGRP-IPv4 Neighbors for AS(1)H Address Interface...
The interface "bandwidth" command like you have configured does not apply to QoS. It is for routing protocols like EIGRP, etc. There is also a "bandwidth" command you use under a policy-map which is used for QoS.QoS example using bandwidth:policy-m...
Can you paste in the "show version"? Also what type of interface are you trying to apply PBR on? Could you paste in the configuration on this interface? Does the switch give you any error when you try to apply the command? Please paste in "show s...
Adding the /32 route is a good first step. Can you ping from the tunnel source to the tunnel destination? If you can't ping, what does a traceroute show? Make sure you're not seeing any loops from redistributing the host static route into your rou...
