About Kerem Gursu

Kerem Gursu · 12-08-2012

I try to implement Cisco LI MIB on a 7406 VXR chasis. I issue the command from the mediation devicemerlyn@revan ~ $ snmpget -v3 -u liuser -a MD5 -A password -l authNoPriv 192.168.111.1 cTap2StreamInterceptEnablewithin the documentarion cTap2StreamInt...

Kerem Gursu · 08-07-2006

Hi , Is it possible to announce within OSPF the seocndary address on any interface

Kerem Gursu · 10-13-2004

Hi ,I am trying to set up an SVC between two routers that are connected back-to-back via ATM interfaces. When I set up the following configuration , I can see the signalling events in the debug output but I am not able to ping the interfaces. Is it p...

Kerem Gursu · 06-25-2004

During the configuration of a bgp default route announce,"redistribute static" and "default-information originate" must be defined under bgp conf. Also the default route should be known as a static route entry in the general conf. I thought the stati...

Kerem Gursu · 02-22-2010

Hi Alex,If your application that is supposed to be connected to your LAN needs direct reachability to the end nodes or it uses L2 protocols , you can try bridging your LAN and the remote office LAN.HTH,Kerem

Kerem Gursu · 07-18-2009

Hi Cheng, Cisco CRS series routers (like GSR routers running IOX ) act slightly different than other routers. Cisco IOX has a built in mechanism called Local Packet Transport Services (LPTS). LPTS is made of various different components , but in your...

Kerem Gursu · 03-10-2009

Hi Guatam, According to your output , especially your 1 hour graph show periodic spikes. CPU reaches to a peak value , followed by a fall down. This has happened periodically , which makes me think of a periodic activity like a Network Management Ser...

Kerem Gursu · 02-27-2009

Hi Hunt, You can use set port host which will set your port to access mode and perform portfast. After doing this , you can assign the correct vlan to your port.Hope to help, Kerem

Kerem Gursu · 02-24-2009

Hi Prima, Cisco IOS software running on the supervisor engine and the MSFC supports redundant configurations when the supervisor engines and MSFC routers are identical. If they are not identical, one will boot first and become active and hold the oth...

Member Since	‎06-23-2004 02:44 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	36
Total Helpful Votes Received	27

User Statistics

User Activity

Cisco LI MIB

OSPF & Secondary Address

ATM B2B connection SVC setup

BGP default route announce

Re: How do i set up an ip to have direct accessibility?

Re: astonishing problem of ping between CRS and GSR

Re: CPU usage high on 6500 with Sup 720

Re: CatOS

Re: SSO hardware requirement