Have CAT2950s, 3550s, & 3560s that have converted from VTP client mode to transparent mode & used config mode instead of vlan database to make the changes.Now, am unable to add vlan using config mode nor vlan database and am rx the following error:"...
I am setting up QoS for VoIP on several routers. I have two questions:1) For PPP multilink interfaces, do I apply the service-policy on the multilink interface or on each of the serial interfaces that are a member of that ppp multilink group?2) For ...
Using Cworks, receiving multiple physical discrepancy error messages regarding T1 Link speed mismatches like the following:"This link has ports with mismatching interface Speed.Port Serial0/0 on device ROUTER_A with ifSpeed 1544000Port Serial0/3/0:0...
I have a 2924XL ver12.0(5)WC11 connected to two 3550 ver12.1(22)EA5 via 802.1Q trunks. They are all in the same VTP domain. The 2924XL is in VTP Client mode & the two 3550s are in VTP Server mode. There are only 6 vlans - 1, 223, 1002, 1003, 1004,...
Deploying VWIC-2MFT-T1 cards in various routers & are experiencing errors & drops. Does anyone know if there are any known issues w/these cards? Also, regarding clocking, is there a particular way these cards should be configured, e.g. if there are...
That appeared to be the problem. After I disabled VTP pruning on the server, (you can only disable pruning in server mode & it auto propogates to the clients) I was able to convert both server/clients to transport mode w/o any interruption of servic...
But the vlan info is there, when performing a "show vlan" both VLAN 1 & VLAN 223 appears including the ports that are assigned to each VLAN. Also note, this scenario was reproduced at another site w/the same setup.
