Hi,Please I want to find out if it is possible to use all uplinks ports on the 8 port Sup8-E modules configured as a redundant pair on a single 4510R+E chassis?I noticed that only 4 ports are active on each sup8-E modules (making it a total of 8 port...
Hi,Please I have question about vpn split tunnel for internal hosts that we need to be accessed via the internet.My split tunnel works ok but at the moment we want to exclude some of the tunneled domain hosts from being accessed via the tunnel but in...
Hi Everyone,Please I need a clarification on configuring a PAT (or portforwarding) of RDP to 14 pcsusing a single public ip address on my ASA version 8.4. Please any info or example config willbe appreciated as I am still geting used to 8.4 from my o...
Hi,Please I need some clarification and help with configuring my ASA 5540 with IOS 8.3x for remote client certificate authentication.I have my root certificate from the Microsoft CA but not quite sure if the outlined steps in the cisco websites below...
Hi,Please I need some help with a vrf-lite deployment which is currently working ok at one of my sites. But the problem I am now facing is ho to tag some interesting traffic sourced from vlans within the two seperate vrfs I am using. The first proble...
Thanks Mariusz,I have implemented a solution which seems to be working ok although I have not put it in my production network.I have combined the split-tunnel with internal ACL rule which prevents the remote vpn pool address from contacting the inte...
Hi Mohammed,Thanks for your response.I already have the outside firewall interface being NATed as you suggested but it still didn't work.But I found out the problem was with my tunnel-group and ssl-client config and it has been working for 2 days now...
Hi,Please did you get to resolve this issue?I currently have a similar setup as shown below and about to implement AnyConnect vpn on version 8.4(2)Internet --> edge device (with Public IP) --> ASA (with Private IP) --> LANThanks
