Hi Guys,
We have some Cisco 9500 switches in our network running version 16.6.5 and I'm still getting the error message.
Not sure if anyone else is having the same problem. When you do the work around, something else times out. You work around ...
I have a Cisco 5520 HA pair and want to increase the license count so that additional AP's can register. I have an RTU license, please see the output below. I want to know how I can increase AP count to without "breaking" (reaching the limit of) t...
I have a HA WLC 5520 and we have ordered some new AP's (AIR-AP2802I-E-K9). They connect and register to the WLC however, they do not pass any traffic through the WLANs. Looking at the cisco help forums I can see that CSCvc67005 is the problem. Thi...
Hi Guys,
I’m having trouble configuring a Cisco ASA 5540 in transparent mode:
The current topology is below:
!
!
I would like only specified host/IP addresses to communicate with 192.168.0.101 and vice-versa, these devices are on the same...
Hi Everyone, I have a FQDN object on our Firewall, the IP address of this changes daily so the firewall has a rule to permit access to it on a specified port number. Example:access-list inside_access_in line 284 extended permit tcp host 192.168.0.25 ...
Hi,
When you upgraded to 8.3.143.0, did you upgrade and reboot both the primary and standby? Also, did you make sure all of the AP's upgraded to software version 8.3.143.0?
Thank you
phipse
Thank you everything is working fine now.
@Sandeep Choudhary wrote:
try to upgrade to 8.3.143.0 which will support both types of AP (1142 and 2800)
Regards
Dont forget to rate helpful posts
Thank you Sandeep.
Which brings me back to Flavio's question. How would Cisco know? If I change this back to 130 at a later date would that impact my license?
Thank you
