About pmccleese

pmccleese · 09-19-2018

After several hours I keep coming back to the same issue. Assigning an IP to Fiber port (enp9s0) with10.10.10.1 / 24 - GW: 10.10.10.220 (HSRP address on cores for vlan 10), and DNS IP. I use this vlan for management of Cisco network devices and it h...

pmccleese · 09-24-2018

Thank you. That was part of the solution. The other part was I had to have the correct DNS IP in the interface to make it accessible to the internet (it does some sort of check after you configure as it reaches out to a host and if it can't reach tha...

pmccleese · 09-19-2018

Note: The descriptions are off on port diagrams under Figure 2. Rear Panel, Cisco DNA Center Appliance (DN1-HW-APL) <in other words #'s do not match physical interfaces>

Member Since	‎07-28-2016 09:04 AM
Date Last Visited	‎03-13-2020 02:22 AM
Posts	3
Total Helpful Votes Received	5

User Statistics

User Activity

DNA network config question

Re: DNA network config question

Re: Fiber ports on DN1-HW-APL