Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I have two sites geographically separated and I am troubleshooting an issue with our sys admins. The provider of the service were having issues with said that multicast must been used between the 2 SVI subnets that each site has for our LFD...
Good Morning all!I have a second ISP circuit added to my network for redundancy. I have built and designed a topology that uses an FHRP to cut over in the event our primary router fails. I have a connection from Starlink coming into the building. I w...
I think I answered my own question here. Youre right. I dont need to have each SVI communicating via multicast from site to site. I just need each SVI to communicate through multicast in each of their respective LANs. The firewall policies allow mult...
I don't believe so. Each site is its own source, RP, and destination. The Core switches have RPs (loopback interfaces) assigned that will be listening to the Source (SVIs on each Core), and the destination will be the devices connected to the Acc Swi...
There will be a firewall implemented in this build as well. We wouldn't need this device to support firewall capabilities as well. It seems that the Cisco 1000 ISR router would probably be our best bet in this senario.I appreciate the response and yo...
