Hi,I am using the UCS Emulator v1.3 and I cannot find a way to connect to the ESX host that comes pre-installed with it. Also the v1.4 Emulator is stuck on "Starting Cisco UCSPE & UCS Manager: 203%" and increasing...Any help would be appreciatedRegar...

I am currently setting up a new office and we need a switch that has 10G interface for a test purpose. However we would also like to use the same switch for our office phone setup and would like to power the phones from the switch.If not I will proba...

I am running RIP between CPE and PE and it is working - I can see the RIP routes in the VRF routing table. However I cannot see the RIP routes on the CPE, which I need to be able to do.PE RIP Configrouter ripaddress-family ipv4 vrf ABCredistribute st...