yes, but on version 7.1, and not 7.0. You'll have to add the subscriber ip address on the publisher using gui before you complete the install of the subscriber for forming a cluster, since it checks for that reference during the install for a successful completion, otherwise throws an error. hope this helps Thanks ... View more

True, like Paul said, resource should be close to the source. ... View more

on CME, Try: config t telephony-service time-format   <--- for Time setup Date-format <--- for date display if this helps, please rate the post. thanks TG ... View more

The list will cary an ephone-dn. Therefore instead of a destination pattern, you can create an ephone-dn of 109 with desired options. ... View more

I see a problem in your translation rule, there is one dot extra, and one "X" extra you have on. PSTN numbers are 10 digits, you have a rule for 11. Try fixing that, also besides this, remove the mgcpapp from that Pots dialpeer, there is no need for that as it's a PRI. However down in your router config you have: #show run | sec voice trans voice translation-rule 1 rule 1 /\(...$\)/ /2\1/ voice translation-profile prefix2 translate called 1 Now you should be either getting 10 digits from PSTN or 4, if you are getting 4 digits, then there is One MORE Dot needed in that rule above to match. If you are getting 10 digits, then that rule has to be modified based on the digits you are getting. Example for 4 digits should be; Voice Translation-rule 1 rule 1 /\(....$\)/ /2\1/ hope this helps. cheers. ... View more

You can reset the MOH server, and also try resetting media streaming service. this should be done in maintenance window, and should clear this out. hope this helps, if it does, please rate. cheers. ... View more

Any suggestion on this one? Here is one clue I can provide. When you go to UC Administration page, and click on Message Storage>Mailbox Sotres Click on the mail database link Against the server field, it shows the older name, even though everything has been changed to the new one. PLUS this name is all greyed out so one cannot tweak it in this field, it just displays and is greyed out. How do we correct this to the new hostname of the server? (OR) does it matter if we really have to? I like things consistent which is why this is bugging me. thanks for your help. ... View more

Bump it up to say 36 will approximately allow 3 more rings, and test out. cheers ... View more

You can go to "service parameters" and then select "Call Manager" , click on the advanced button. Find the parameter called "Redirection Ring No Answer Reversion Timer:" and increase the value to a higher value. You may have to restart the call manager service after tweaking this parameter, you can always test it without restarting the service though. hope this helps, if it does, please rate! cheers ... View more

I've gone through those steps and all of them were followed. Replication is fine, and is verified through rtmt and also cli. ... View more

Hi Thomas, thanks for reiterating this and that was the reason behind going with IP addresses. I appreciate your input. Still looking answers on the other query I posted. ... View more