wkamil123
Level 1
Level 1
Member since ‎08-22-2006
‎02-23-2024

User Statistics

  • 111 Posts
  • 4 Solutions
  • 15 Helpful votes Given
  • 9 Helpful votes Received

User Activity

Hello I have an issue with a 9115E AP where for 2.4 radio is active only B connector. The question is how to activate others 4 connectors. Is this model has any limitations? My installation and AP use is that two antennas are installed in two differe...
Hello,I have an installation of Prime Infrastructure 3.8 with some switches, like Catalyst 9200L and Catalyst 9500. The communication is configured by SNMPv3 and all works fine but the dashboard metrics do not show clients summary. However, clients a...
I have a 9200L switch with 16.9.5 software version and want to run 802.1x on a port where phone and PC are connected.The phone and PC are successful authorize on separate ports but when they are connected together, switch authorize only phone. Wiresh...
Hello,I have a little issue to configure policy to TACACS+ device authentication to authorize users from local and AD users on one policy.In first policy when the user is not found in local store then the second option is not taken - AD Domain.If use...
Hello, I had a situation where stack of two 9300 switches was upgraded from 16.06.03 to 16.06.05 and it couldn't boot up properly. The upgrade procedure was always the same, place the new image on USB flash and run command request platform software a...
Community Statistics
Member Since ‎08-22-2006 09:10 AM
Date Last Visited ‎02-23-2024 12:04 AM
Posts 111
Total Helpful Votes Received 9
Helpful Votes From
Helpful Votes Given To