Can anyone tell me why I am getting these inconsistent traceroute results fromone switch? Why does switch 172.23.31.8 trace fine to 172.23.30.1 but switch172.23.31.6 is sent to the default route when tracing to 172.23.30.1 ?See attached diagram. Than...
Can anyone tell me why Vlan1 10.90.152.0/24 doesnot show up as directly connected in the routing table?It's also is not advertising to other routers.When I only configure one 192.168.0.x routed interface, thenthe Vlan1 shows up. I'm missing something...
Hello Experts,I am trying to set up a ring in a lab but have oneissue with eigrp. (diagram attached)When I pull any one of the links, the routing tableupdates no problem to re-route traffic the other way.But when I pull the power on one of the router...
Hello experts,The routing table of E3 shows the two routes to the 10.90.153.0/24 network,via 172.23.31.53 and 172.23.31.24.When I disconnect the link between THCC_1 and Test_1, the routing table onE3 updates to show just the one route via172.23.30.24...
Can anyone please tell me why these two 3560's are not routing?Test#sh runBuilding configuration...Current configuration : 2605 bytes!version 12.2!no aaa new-modelip subnet-zeroip routing!no file verify autospanning-tree mode pvstspanning-tree extend...
Switch ports look normal in all aspects. See below.On the firewall, I don't see any ARP entries for the 172.23.31.6 or 172.23.31.8 switchesprobably because those specific IPs don't often traverse that firewall for anything.I see ARPs for clients conn...
The routing table looks normal. Switch 172.23.31.6 was recently replaceddue to hardware failure, and this strange behaviour seems to have startedwith that replacement. Not sure what the problem is. Thanks.show ip routeCodes: C - connected, S - static...
Is there a way I can simulate having Vlan1be up without actually having a client on aport? I have (8) 3560's I'm testing but don'thave (8) clients I can connect to each...Thanks
