About mdbamel17

mdbamel17 · 08-02-2016

Hello, I want to isolate traffic from my guest ssid in a seperate vlan and just route it to the internet, but clients on that ssid don't receive an ip address: Here's my setup: RV180 router : On all ports vlan id 1 is 'untagged' and vlan id 2 is ...

mdbamel17 · 10-16-2015

Hi,I'm experiencing slower speeds on ports that are used for uplinking on my RV180:- when plugging my laptop directly into the RV180 that is used as WAN router, I have nice wanspeeds of ca. 98 mbps- when plugging into the SF302-08P 8-Port switch that...

mdbamel17 · 08-09-2016

Hi Jonathan, Thanks for your reply. -If you plug the computer directly to the router on a port that has vlan 2 as untagged and vlan 1 as tagged. Do you get an ip from the correct segment? Yes, I get an ip adress in the correct segment of vlan2 ...

mdbamel17 · 10-22-2015

I tried connecting the SF302-08P 1G interface with the RV180, they negotiated 1G full duplex and everything flies so I'll have to replace the d-link switch with something decent :)You were absolutely right about the port negotiation. Thanks a lot man...

mdbamel17 · 10-18-2015

Ok, I will do the test with the RV180 and the SF302-08P that I have. It has 2 gbps ports.Keep you posted.

mdbamel17 · 10-17-2015

Thanks for your answer.I checked port speeds on the RV180 but I'm not sure that status>port statistics table is correct.1) It reported an operational mode of 1000 FULL on port 1 which can't be true because the d-link unmanaged 10/100 switch is behin...

Member Since	‎10-16-2015 01:32 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	6

User Statistics

User Activity

WAP121 Guest SSID in seperate VLAN - no dhcp lease

RV180 slow uplinks

Hi Jonathan,

I tried connecting the SF302

Ok, I will do the test with

Thanks for your answer.I