About Mark Wright

Mark Wright · 08-17-2016

I have a config on a usb stick called ciscortr.cfg. In this config I have a eem applet that I want to run to configure the outside interface. But this applet will not run because the setup dialog "Would you like to enter the initial configuration dia...

Mark Wright · 08-02-2016

If I copy a file from the 881 router without VRF it takes 0.776 secs (180 bytes/sec) to copy 140 bytes. I setup VRF and set my Ip ssh source-interface to FastEthernet4 it takes 11.188 secs (13 bytes/sec) to copy 140bytes. In both I copied the same ...

Mark Wright · 08-23-2012

I have been able to get https to work from IOS command using copy or more. I have also able to get http gets and posts to work form TCL scripts. But what I need to get to work from TCL is Secure HTTP (https). I am using a 881-W Router. The http.tcl f...

Mark Wright · 04-30-2018

check to see if you device supports the new vrf definition conf t vrf definition ? If it does change to vrf definition from ip vrf. I found this speeds up scp.

Mark Wright · 08-19-2016

Bharat, This is what I want to do. 1. do a "wr erase" 2. ship the router to a site. 3. put a usbkey that has a config and an eem applet on it. 4. insert a network cable to a network that does not have a dhcp server. 5. turn on the router without a co...

Member Since	‎08-23-2012 03:01 PM
Date Last Visited	‎07-24-2018 12:44 PM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Boot 4300 series router without dhcp don't want setup dialog.

SCP with vrf takes a long time to copy file.

How to use HTTPS with TCL on a 881-W router?

Re: SCP with vrf takes a long time to copy file.

Bharat, This is what I want