Hello, I have been playing around with both CAT9300V models in CML. I am trying to create a L3 port and setup eigrp neighbor between an IOSv device. when I create the L3 port I see the port in an UP UP state but I can not ping across to the othe...
I am trying out a solution using an ISR 829 with a cellular connection. This device will be a spoke in a DMVPN setup. It successfully connects with the hub and I am able to ping the Hubs tunnel address as well as ping between the sites behind the t...
Hello, I am trying to figure out why NATing with certain ports on the ASA is failing. It seems when I try to NAT ports 22 or 443 on the inside of my network I do not get successful connections but if I take and modify the NAT to a different port that...
Hello, I am new to the Firepower Threat Defense products. I am trying to set up an external NAT that will forward ports to my internal network. I have tested the NAT rules on high ports such inside-x.x.x.x:8000 <-->outside-x.x.x.x:8000 and it seems...
Hello, I have a wan site that has 2 routers with 2 wan links(separate carriers) and 2 switch stacks(1 stack of 5 and 1 stack of 4).
In the pictured diagram each router is configured with a port-channel connected to the stack below. This connection wi...
Cisco AnyConnect's Start Before Logon (SBL) feature establishes a VPN connection before logging into Windows. This feature is only available for Windows platformsI believe you can use the following on the Mac though:Automatically Start VPN Connecti...
you could try the following:no ip nat service sip tcp port 5060no ip nat service sip udp port 5060ip nat inside source static udp 192.168.0.7 5060 <Outside_IP> 5060 extendableip nat inside source static udp 192.168.0.7 10000 <Outside_IP> 10000 extend...
yes the port is up/up on both sides but I am unable to ping from 9300 to IOSv. I switched it from 9300V Doppler to 9300V SiliconOne and it seems to work now. not sure what was going on
Make sure you trunking VLAN 99 between the switches. Do all of the switches have an ip on VLAN 99 that is on the 172.168.0.0 network? it also looks like your mask is wrong on int vlan 99 (172.168.0.1 255.255.248.0) should it be 172.168.0.1 255.255.25...
