About dale-sheedy

dale-sheedy · 07-21-2014

Hi, I have a 881G router with the dialer interface up and working. I have 2 vlans which are able to ping between and the router can ping the internet from the source vlan interfaces to the internet but computers on the fa interface do not. With NAT d...

dale-sheedy · 08-24-2012

How can I route all traffic from Vlan 10 to 20VLan 20 to 10Vlan 30 to 10Vlan 10 to 30 and so on.Meaning all nominated vlans route all traffic (including multicast) to vlan 10. But those vlans are denied access to each other?or, how can I isolate port...

dale-sheedy · 07-21-2014

So not sure of what the issue was but after upgrading IOS and dropping back to a non binded dialer interface, it is working, below is the working config with telstra.wap settings for 3g. The 3 G passwords are not required and are just placeholders. C...

dale-sheedy · 07-21-2014

vishalvyas1986 below are the results:Router#ping 4.2.2.2 source 172.16.0.4Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 4.2.2.2, timeout is 2 seconds:Packet sent with a source address of 172.16.0.4!!!!!Success rate is 100 percent (5...

dale-sheedy · 07-21-2014

Thanks Emmanuel, I see a line of config that differs. ip nat inside source route-map Internet interface Cellular0 overloadMy config it ip nat inside source list 100 interface Dialer1 overload also I have the dialer and cellular both have "ip nat out...

dale-sheedy · 07-21-2014

Emmanuel, I added that config but still no joy. I do believe NAT is working as per below debugging Jul 21 23:30:36.399: NAT*: i: tcp (172.16.0.10, 50836) -> (74.125.237.120, 443) [7164]Jul 21 23:30:36.399: NAT*: s=172.16.0.10->10.162.49.144, d=74.125...

Member Since	‎08-24-2012 12:43 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	7

User Statistics

User Activity

881G router issue connecting to WAN from LAN

Expert CCIE needed

So not sure of what the issue

vishalvyas1986 below are the

Thanks Emmanuel, I see a line

Emmanuel, I added that config