Ok, on my Dell Precision with an Intel 5100 agn wireless nic the link speed tops out at 72mbps and I checked on a different laptop with an N wireless nic and it also topped out at 72mb and that's sitting right next to the access point. Edit: Ok the Intel 5100 is apparently just crap, I set it to 20mhz only instead of auto and now it's connecting at 144mbps which is closer to what I expected. My understanding is that I can't get the full 300mbps without a MIMO card.
... View more
I purchased a new ap1041n access point. It's the first Cisco I've tried to configure in a long time. I'm trying to get the 802.11n working but it seems to be stuck in 802.11G since I can only get it to go up to 36mb. The radio says its running in mixed mode and I can't figure out if that means b/g or b/g/n. I ran the Express Setup and it didn't seem to help me. I'm hoping it's an easy fix. I posted the config below, if anyone can help me it would be greatly appreciated. ! version 12.4 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname AP ! logging rate-limit console 9 enable secret 5 $1$36ve$pm3oh52Ka.KyxGeMa9W7C1 ! no aaa new-model ip domain name hyrule ! ! dot11 syslog ! dot11 ssid Test authentication open authentication key-management wpa guest-mode wpa-psk ascii 7 1521040F0B0B26253A3621361C2B1F0E04 no ids mfp client ! ! ! username username ! ! ip ssh version 1 bridge irb ! ! interface Dot11Radio0 no ip address no ip route-cache ! encryption mode ciphers aes-ccm tkip ! ssid UNSC ! antenna gain 0 speed basic-1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 24.0 36.0 48.0 54.0 m0. m1. m2. m3. m4. m5. m6. m7. m8. m9. m10. m11. m12. m13. m14. m15. station-role root no dot11 extension aironet bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding bridge-group 1 spanning-disabled ! interface GigabitEthernet0 no ip address no ip route-cache duplex auto speed auto no keepalive bridge-group 1 no bridge-group 1 source-learning bridge-group 1 spanning-disabled ! interface BVI1 ip address 10.10.0.251 255.255.255.0 no ip route-cache ! ip default-gateway 10.10.0.1 ip http server no ip http secure-server ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag access-list 111 permit tcp any any neq telnet bridge 1 route ip ! ! ! line con 0 access-class 111 in line vty 0 4 access-class 111 in login local ! end
... View more