About dfulguer

dfulguer · 11-29-2013

We are installing SPA-5X1GE-V2 on ASR1002 and I need a redundant link from the router going to two different L2 switches. To do this, we need to configure SVI and access VLAN ports. I usually configure SPA for L3 port connection but not with L2. C...

dfulguer · 02-20-2012

our WAN is connected via L2WAN and using EIGRP to connect the sites. Currently there are 35 EIGRP neighbors over L2WAN and we are to install 15 more sites and will be connected to the same L2WAN. Some sites are still using Cisco 2651XM and we would...

dfulguer · 09-06-2011

I have this network setup:remoteR0------- GRE/IPSec (eBGP) ----------- < HubR5 -----------CoreSW (iBGP/EIGRP) ------ HubR1 >--------- MPLSI have networks in remoteR0 that I advertise via eBGP to HubR5.HubR5 received it and redistribute it via EIGRP a...

dfulguer · 01-15-2019

looks like this is the command to change it:packet-gap non-standardhttps://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-1/interfaces/command/reference/b_interfaces_cr41crs/b_interfaces_cr41crs_chapter_0101.html#wp2797037196

dfulguer · 02-21-2012

Thanks Guys... very much helpful. Cheers

dfulguer · 02-20-2012

Hi Vivek, thank you. The smallest/oldest router we have is Cisco 2651XM with 64M memory. I guess it can still accommodate 15 more neighbors... how about the number of routes on the routing table? Any limitation for smaller routers?

dfulguer · 09-13-2011

hi marwanshawi, hi harish.thanks again for your assistance.Cheers!

dfulguer · 09-07-2011

Thanks Marwan, Thanks Harishnot sure if we can do that.the GRE/IPSec tunnel from remoteR0 to HubR5 is just a Backup connectionfrom RemoteR0, we have another router connected to the same MPLS cloud of HubR1So from Hub site, we primarily learn the rout...

Member Since	‎11-28-2005 04:12 PM
Date Last Visited	‎02-23-2022 12:07 AM
Posts	10

User Statistics

User Activity

ASR1002, SPA-5X1GE-V2, SVI and Access VLAN

eigrp number of neighbors limitation

routing loop when advertising specific subnet of another AS

Re: I thought I'd put a follow-up

eigrp number of neighbors limitation

eigrp number of neighbors limitation

Re: routing loop when advertising specific subnet of another AS

Re: routing loop when advertising specific subnet of another AS