About matt

matt · 08-27-2012

Trying to get the following working:ephone-dn 120 dual-linenumber 1120label Matt 1120description Mattname Mattmobilitysnr 81XXXXXX1952 delay 0 timeout 10 cfwd-noan 1198snr ring-stopcall-forward noan 1198 timeout 3call-forward busy 1198 primaryno hu...

matt · 08-03-2008

I've installed a second PVDM and the hw shows up in sh diag, but I can't use the voice-card 1 or 2 to utilized for transcoding or conferencing. I've attached sh ver and sh diag. The unit is a 2821 with CME 4.3/7.0. Any ideas on this whether it's a...

matt · 04-18-2008

From release notes and included files, it looks like the 7937 is operational with CME 4.3. However when I go to add the load, it is not available on the list of phones. CME Says it's registered, but it never registers. Anyone able to get this to w...

matt · 12-31-2007

Anyone know if the ASA will be supporting SNMPv3? I've asked TAC and they respectfully declined to answer and I never heard back from our SE.

matt · 04-29-2007

I've connected an IP security camera that has SIP phone capabilities to our CM 5.1. All the phones are Cisco SCCP phones. The camera is fully registered and can call any extension in our calling space. However when I try to call the camera from th...

matt · 08-28-2012

Thanks, nightbell was part of the issue and the other part was the need to update to 9.0.

matt · 04-02-2012

Any word when there will be documentation for this? I've looked everywhere, but can't find any references to setup on CME.

matt · 11-03-2009

Does this apply to all static NAT'ing on this device? Makes it pretty useless for anyone who has a server they need to expose. Can you do a PAT only without a one-to-one? I think this will be the last time I get burned by this Cisco SMB stuff. Al...

matt · 12-29-2008

I'm running into the same error and have forwarded the error to my ITSP for their review. I am behind an ASA with SIP inspection on. I've attached the text file with the error message. Outbound is fine, inbound does not work.dial-peer voice 1001 v...

matt · 05-14-2008

load 7937 apps37sccp.1-2-1-0No .bin for the load statement should get that load on there.ephone 9 device-security-mode none description ***** Conference Phone ***** video mac-address 0004.F2E1.0A92 paging-dn 101 codec g711ulaw type 7937 button 1:1...

Member Since	‎02-04-2006 08:40 AM
Date Last Visited	‎10-08-2017 09:35 PM
Posts	32
Total Helpful Votes Received	5

User Statistics

User Activity

SNR on CME 8.6

Add'l PVDM hardware detected, not available

CME 4.3 7937

SNMPv3 ASA

Third-Party SIP camera

SNR on CME 8.6

Cisco Mobile 8.0

Re: Cisco SA540 and problems with NAT

Re: Incoming calls to SIP trunk on CME 4.0.3

Re: CME 4.3 7937