About Luisinus

Luisinus · 03-15-2007

I bought a 1841 Router on e-bay.Apparently, it has been configured with "no service password-recovery". The console shows: PASSWORD RECOVERY FUNCTIONALITY IS DISABLED, and it does not respond to Ctrl-Break during boot. AFAIK, this router does not hav...

Luisinus · 01-27-2007

I connect 2 routers via 2 wireless links. One primary, one backup link.The wireless devices block broadcast traffic, so I'm bound to use the "neighbor"command in order to have EIGRP packets been sent as unicast.In fact, this HAS been working before, ...

Luisinus · 04-23-2003

I need to capture traffic counters via SNMP.Doing this on the interface traffic is rather trivial, and the OID-s are easy to find.What I need is to monitor the byte traffic on a specific IP address.I have setup traffic shaping (traffic-shape group) w...

Luisinus · 11-27-2009

By the way - while digging in old posts, some sentences made me wonder:First:>>>>With this feature enabled, a hacker with physical access to the router cannot enter the ROMMON and ignore the startup config.<<<<A hacker with physical access is usually...

Luisinus · 11-27-2009

Hi Christopher,My original post is more than 2 years old, but the issue was never resolved.I had sent the router to a company in the US that claimed they could do it, and it came back stone dead. (No LED indicators, no RS232 response anymore).Either ...

Luisinus · 03-19-2007

I have been through 25-30 reboots, following the different recommendations where some say to hit Ctrl-Break when when "Image text-base:" appears, other after 5 seconds into boot etcetc. I have even tried another terminal program, but the fact that se...

Luisinus · 03-15-2007

Well, here the steps taken so far:- About 20 reboots with console cable connected. I have hit Ctrl-Break at every thinkable point, after 5 secs. after boot, when "Image text-base:" appears, etcetc.- I cross-checked with another 831 I have around to s...

Luisinus · 02-19-2007

We run a Ptp link (Trango) that does pass broadcasts, and the backup link is simple Client Premise equipment (That does not pass broadcasts).Go and try it. If you find that you don't get a neighbor association (sh ip eigrp neigh), then you most likel...

Member Since	‎04-23-2003 10:15 AM
Date Last Visited	‎12-24-2022 05:33 PM
Posts	15

User Statistics

User Activity

Password recovery

EIGRP neighbor woes

Traffic counters / SNMP

Re: Password recovery

Re: Password recovery

Re: Password recovery

Re: Password recovery

Re: EIGRP neighbor woes