HI all,
I have a Voip environment with a 2901 router. All internal calls are working fine. When I dial an external number (using the PSTN) I have no audio at all on both ends. The phones ring and the communication is established, but no voice. There ...
Hi all,
I have a Cisco 2901 with CME 15.4. I have a couple of 7821 and an analogue phone connected to it. As soon as I turn on
debug voice dialpeer
I have a verbose output activity, apparenlty numbers called randomly. All my phones are on-hook though...
Hi all,I am trying to connect an analogue phone to my Cisco router through a VIC3-2FXS card plugged on slot 3. Router runs Version 15.4(3)M3, RELEASE SOFTWARE (fc2). I have tried a couple of different phones but I cannot get any dial tone.Here my con...
Hi all,I am trying to connect an analogue phone to my Cisco router through a VIC3-2FXS card plugged on slot 3. Router runs Version 15.4(3)M3, RELEASE SOFTWARE (fc2). I have tried a couple of different phones but I cannot get any dial tone.Here my con...
Dear Ayodeji, good morning
I asked t move the cable to ISDN BRI S/T 1 and I configured the dial-peer in order to test a phone call. Unfortunately I have the same behaviour (inbound and outbound). I can see traffic and call generated from output and t...
This is on a remote site and the persons there aren't skilled enough. I could try to instruct someone with pictures and try the other port. I'll try and let you know.
Incoming calls have exactly the same issue.
Thank you
