HelloI have two routers CISCO2801 (12.4(9)T6, ADVIPSERVICESK9) and a CISCO1841 (12.4(25f), ADVIPSERVICESK9). IPv6 is configured on both routers and works fine over the internet. Now I had some some trouble to setup IPSec on the 1841 router. On the 28...
Hello allI have the following configuration but I'm not shure is this really supported on the IOS 12.3(24)I running on.ISP/Internet--Cable Modem--Router--LAN DHCP--|--192.168.1.0/24ISP provide dynamic assignet ip address by DHCP ...
we have hundreds of switches we have saved the configuration on the Cisco Works. At the time we have to use a saved configuration for a replaced switch (new hw) to reconfigure, the switch does not accept the duplex configiration (Message: Duplex can ...
I didn't found some documents on the CCO with exact descrption of the performace of the Cisco 1760 router. Where can I find suche kinde of information?Thanks, Rolf
I would like to dial in with my PC ISDN adapter to my Cisco 2610 with a WIC-1B S/T. The config is as follows. If I dial in to the router all is working correct but the idle timer is not reseted if I start a ping or a telnet session over this establis...
Hello Rickthank you for the replay. It seems this is not supported on the IOS 12.3 version. My configuration looks simalar as yours. I attached my configuration with changed passwords and ip addresses. A ping from a inside host to the outside is only...
Hiin between I found a bug ID for that problem CSCec13983 affected device is Catalyst 2950 but I have the same on Catalyst 3550 and 4506. The bug is fixed first in 12.1(20)EA1. I installed for a test the latest version 12.1(22)EA3 and it works fine....
sorry I copied the wrong config, here is the running config. But the idle-timer is still not set back to max. I opened a telent session to a local router and started a debug to produce some traffic over the link which should be qualified as interesti...
