About Aaron Ratcliffe

Aaron Ratcliffe · 04-25-2018

As you can ping from WAN interface is sounds like NAT outbound, please paste show run from CLI and make sure your NAT overload ACL and configuration is referencing the correct interfaces https://www.cisco.com/c/en/us/support/docs/long-reach-etherne...

Aaron Ratcliffe · 07-15-2014

Please check dial peers session targets as both sites are pointing to 192.168.2.1 this seems in correct of they are 2 different systems yet both pointing to the same IP ?

Aaron Ratcliffe · 07-15-2014

If I'm reading correctly these are 2 different systems ? If so why is the session target for the dial pees the same IP ? Try change the session target of site A's dial peer to site B's systems IP address

Aaron Ratcliffe · 05-13-2014

Hi There , This is correct , you may need to try re add contacts as a test also .

Aaron Ratcliffe · 05-13-2014

Hi there , Is it possible to post screenshots of the cluster configuration pages ? Please make sure your route patterns are correct and each side of the trunk has a incoming CSS that can access the required phones on either side . ThanksAaron

Member Since	‎08-09-2012 12:54 AM
Date Last Visited	‎04-26-2018 03:11 AM
Posts	21
Total Helpful Votes Received	5

User Statistics

User Activity

Re: Setting up ISR 4431 - WAN Issues

Please check dial peers

If I'm reading correctly

Hi There , This is correct ,

Hi there , Is it possible to