About Mel Popple

Mel Popple · 08-30-2012

The client has an outside ASA in transparent mode which has the "sysopt connection permit-vpn" enabled, there are also ACL rules to only allow certain outside Internet located routers to create VPNs to the internal ASA.How is it best to log connectio...

Mel Popple · 06-14-2012

I am trying to move a device from the Default location to a sub group and get the following message when I try (either with IE or Firefox)This System Failure occurred: Index : 0, Size: 0. Your changes have not been saved. Click OK to return to the li...

Mel Popple · 06-14-2012

Hi,I have been given the task of sorting out an ACS 5.3 server, the devices were all imported from an older 4.x ACS server. All the devices where placed in the 'Migrated_NDGs' group which was created by the migration tool.Since I have no need for thi...

Mel Popple · 04-11-2012

Hi,A client has had their FWSM fail, when you try to start the module the switch eventually disables the power to that slot (%C6KPWR-SP-4-DISABLED: power to module in slot 4 set off (Module Failed SCP dnld)). I have turned off diagnostics with 'no d...

Mel Popple · 03-27-2012

Hi,I'm having problems getting FTP to work through two FWSM virtual contexts which are connected via a vrf. All this is configured on a 6500 switch with the FWSM running 3.1(4)CLIENT-----CONTEXT_1-------VRF------CONTEXT_2--------FTP_SERVERAt the mome...

Mel Popple · 08-31-2012

Thanks Julio, that has cleared up some points we weren't too clear about.

Mel Popple · 08-30-2012

Put the FWSM in to multiple context mode and add the vlan interfaces to the relevant context. If you need to route between all the vlans you can use a VRF that has SVIs that inter-connect the FWSM contexts. But make sure you read up about the limitat...

Mel Popple · 06-21-2012

jrabinow,Thanks for the help, it worked well. I had to find where it was referenced in a policy and remove it but after that it work as you suggestedMel

Mel Popple · 06-15-2012

Thanks for the pointers guys, both answers were useful. In the end I exported the troublesome clients to CSV, deleted them and then imported them back. They are now editable via the GUI once again.Our primary ACS was built as a 5.2 and then upgraded ...

Mel Popple · 06-14-2012

Thanks for the quick response. I will let you know how it goes, probably won't be for a day or twoMel

Member Since	‎11-08-2001 05:43 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	87
Total Helpful Votes Received	10

User Statistics

User Activity

ASA 7.3 - logging sysopt connection permit-vpn

ACS 5.3 - Error when changing Device group or Location

ACS 5.3 Deleting Migrated_NDGs group

FWSM maintenance mode - vlan 1

Passive FTP through 2 FWSM contexts via VRF instance

ASA 7.3 - logging sysopt connection permit-vpn

Re: FWSM with Multiple Connections

ACS 5.3 Deleting Migrated_NDGs group

Re: ACS 5.3 - Error when changing Device group or Location

ACS 5.3 Deleting Migrated_NDGs group