I am working on a Cata switch, i am working on bonding ports for increased bandwidth (trying to bond 2 1gb interfaces for 2gb of bandwidth)if i recall coorectly i need to create a channel and then configure both intercaes to use that channel, then ta...

I have a cisco pix 506 and 9 cisco pix 501's the pix 506 is the main firewall that all the 501's VPN into... I have started logging on my pix 506:ABVALVE-PIX(config)# show logSyslog logging: enabled Facility: 20 Timestamp logging: enabled St...

My main pix 506e just lost connection. Yeah the 506 that is acting as the vpn server for all of my locations. i have already checked show version and the pix did not reboot. Is there a way to tell if maybe for some weird ass reason if port e0 are e1 ...

I have a pic 506e and i need to open up port 2122 to accept incoming commections to the internal IP of 10.9.2.202 I have posted my config below.any ideas?PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 autonameif ethernet0 outside secur...

i have a pix 506e in front of my network i have several servers in my network, but there are 6 servers that i am concerned about.is it possable in the pix to put those 6 internal ips in a group and have that group use nating through 1 IP address?