Hi,I have the PRI line which has few DDI numbers. Is there any way that i could restrict the max number of simultaneous calls to the called DDI number?lets say if the ddi number is ****123654 limit it to 5 calls. so max 5 concurrent calls can be land...
Hi,I have two routers connected each other using lease line. The bandwidth between them is 1 Mbps. but i am seeing nearly 2 mbps leaving from Router-1 to Rouer-2. how it is possible? is i am looking in the wrong way? the output is from the serial int...
Hi,Is there any way we could see the high communication flow between the src and dst on the ASA firewall in real time? we could see the top 10 sources and top 10 destinations but it didn't match the flow. Also top 10 seems to be a limication, is ther...
Hi, i want to configure the WPA2-PSK. what is the way to configure it on 1100 series AP. I have different options like TKIP, AES CCMP with combination of wep128/40 bit. which is the corrent combination for WPA2-PSK standard?
HI All,I am looking for a solution that can do all the Gateway webcontent filtering/Antivirus/Antispam/Malware functions. This solution will be used for 300 employees. Any good cisco or non-cisco sloution name will be more helpfull that should be cos...
Hi Kevin,you need to have the dns service so that you can have a IP to name mapping. I don't know whether you have static IP address or not. if you have a static IP address then you can ask your service provider to add the dns record for your website...
The command seems to be there but seems not acceptable when you have resource pools enabled. Is there any way i can accomplish this with the configuration i have provided above. It should be very simple but don't know how to do it.
HI,I have the following config on 5400XM. Can you please tell me where and how can i implement the ' called-number 5557528 max-conn 3' command? I have few other Profiles on the 5400Xm same like below. modem-pool command is not available in AS5400Xm a...
By default, all the ports are in the vlan 1 thats why its not shown in the configuration. even youconfigure it for vlan 1. if you configure the port for another vlan, it will show up in the configuration.
