Hey all.
I just tried booting up our 9006 with the RSP880's in them. Found out there's no OS so I understand I have to TurboBoot and get the VM on there. Problem is, I hook up MGM0 (and 1) to our Management Switch, go through the steps of adding ...
Ok so I cannot figure this out at all and would like to understand what's going on. This is on a Cisco 7600 platform.
Router B has an uplink to Router A via TenGig3/1. The path to get to 10.251.197.10/24 goes through this link.
RouterB#sh ip ro...
I will try to keep this simple. We are looking to redo our WAN which peers with another WAN that we own (different ASNs). We'll call these WAN1 and WAN2. These span across the nation for arguments sake. We have 3 eBGP peers throughout the nation....
Hey guys.
I have no clue what i'm missing here. I have a device that lives on a cisco 4948e that I configured with the IP Helper (on the VLAN). It's uplink goes to an IOS-XR device, which goes to another IOS-XR device and finally to the destinatio...
Hey all. I'll try to keep this brief and to the point while being detailed.
I setup a CCIE home lab and I setup 4 Cisco 3560 switches as i'm going through some L2 labs. My home network is pretty simple. I have FIOS coming into our first floor an...
I kept getting a failed message. Here is the entirety of the process:rommon 19 > boot tftp://10.6.94.4/Users/m200/Downloads/ASR9K-iosxr-px-5.3.3-Turboboot/asr9k-mini-px.vm-5.3.3TFTP server specified is:TFTP filename specified is: Users/m200/Download...
Got it. Ok, so my last question would be, would WAN2 (ASN 64001) then route back into WAN1 (ASN 64002) in the same manner; that is to say, based on location it will choose the closest path? I guess the core routers in WAN2 would have to advertise a...
This most likely would work for egress traffic. I say most likely because I would need to REALLY deep dive and work out how the core would receive these default routes. The main 3 sites outlined in my diagram have the bulk of the edge hanging off o...
