About SS-Shine

SS-Shine · 11-07-2025

We have upgraded IOS to 17.12.05.bin to 17.12.06 but when it reloads switch is in ROMMON mode. Unable to boot to previous version or package.conf.Steps 1 - Copy 17.12.06 from USB to flash:Step 2 - no boot systemStep 3 - boot syste flash:cat9k_iosxe....

SS-Shine · 10-30-2025

PaI am using Packet Tracer to create a Lab. On NY-R1 I am not able to create the port-channel 1.10 sub-interface. Does Packet Tracer allow me to create ether-channel sub-interface? NY-R1(config)#interface port-channel 1.10 ^ % Invalid input detecte...

SS-Shine · 11-07-2025

Thanks Mark,Was rebooted and switch is back to Original IOS. Will try to do it again late.

SS-Shine · 10-31-2025

Hi,Thanks for the response and tip, but I try on R1 - and did not workNY-SW1#config tEnter configuration commands, one per line. End with CNTL/Z.NY-SW1(config)#intNY-SW1(config)#interface porNY-SW1(config)#interface port-channel 1NY-SW1(config-if)#no...

SS-Shine · 10-30-2025

Hello Chris,Thanks for the Tip. I am configuring this in Packet Tracer 9 and it is on router 2901. I do not have option to for no switch port. Also, I need the router port as sub-interface so I can tag my vlans.When I try interface port-channel 1....

SS-Shine · 10-30-2025

NY-R1#sh int port-channel 1Port-channel1 is up, line protocol is up (connected)Hardware is EtherChannel, address is 0006.2a9d.3b2c (bia 0006.2a9d.3b2c)MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,reliability 255/255, txload 1/255, rxload 1/255Encapsu...

Member Since	‎10-30-2025 06:35 AM
Date Last Visited	‎10-30-2025 09:22 AM
Posts	6
Total Helpful Votes Received	2

User Statistics

User Activity

Switch 9410 - Upgraded IOS now in ROMMON mode - Unable to boot

EtherChannel on Router with 3650 Switch

Re: Switch 9410 - Upgraded IOS now in ROMMON mode - Unable to boot

Re: EtherChannel on Router with 3650 Switch

Re: EtherChannel on Router with 3650 Switch

Re: EtherChannel on Router with 3650 Switch