fcoppotelli
Level 1
Level 1
Member since ‎09-27-2004
‎01-29-2019

User Statistics

  • 20 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

 Hi ,yesterday I've added my core switch (WS-C4507R+E) to our Cisco Prime infrastructure server to perform some tests. This morning  I've noticed that  many vty sessions have been opened by the Prime server and I was trying to close them but I'm not ...
Hi,I've a strange command output on a catalyst blade HP 3120 about the output drops. When I issue the command show interface I see the following:SWNCL6#sh int g2/0/2GigabitEthernet2/0/2 is up, line protocol is up (connected)   Hardware is Gigabit Eth...
Hi everybody,I've got two cat 6509 in VSS mode and the at the moment the secondary one is shutted down because I'm replacing a line card (WS-X6708-10G-3C) on it.My question is about the (probable) loss of service that can be caused when I'll power on...
Hi,I've got a stack of 2 new Catalyst 3750 V2 48 ports PoE.All the ports are configured to support ip phones + pc (switchport access vlan X + switchport voice vlan Y)My problem is if I connect one or more Ip Phone model 7960G tey're not powered by th...
Hi,I've deployed a wireless bridge using 2 Aironet Bridge 1310, configured with 4 sub-interfaces to carry 4 Vlans over the radio bridge.The native VLAN is the VLAN 1, it's rightly configured on the trunk interfaces but I cannot ping the directly conn...
Community Statistics
Member Since ‎09-27-2004 01:45 AM
Date Last Visited ‎01-29-2019 01:07 AM
Posts 20