I recently acquired a Cat 4507R, and in going thru the docs I wanted to update the embedded ciscoview to the latest version. I was following the directions in the PDF showing to deleted any existing CV files then to tftp the new tar to the switch, but when following the link for the tar to load onto the switch it tells me that the link is no good...?? Can someone provide a link to the current embedded ciscoview tar. I just deleted the current files and need to get the new ones so I can get the embedded ciscoview working again... I am running the following: SPS4507_01#sh ver Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(25)EWA4, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2005 by Cisco Systems, Inc. Compiled Fri 23-Sep-05 13:31 by ssearch Image text-base: 0x10000000, data-base: 0x114DFF08 ROM: 12.2(20r)EW1 Dagobah Revision 226, Swamp Revision 31 SPS4507_01 uptime is 5 days, 2 hours, 8 minutes Uptime for this control processor is 5 days, 2 hours, 8 minutes System returned to ROM by power-on System restarted at 11:59:42 pst Thu Dec 30 2010 System image file is "bootflash:" cisco WS-C4507R (MPC8245) processor (revision 14) with 524288K bytes of memory. Processor board ID FOX101116NQ MPC8245 CPU at 333Mhz, Supervisor IV Last reset from PowerUp 12 Virtual Ethernet interfaces 202 Gigabit Ethernet interfaces 403K bytes of non-volatile configuration memory. Configuration register is 0x2101 Thanks for you help in advance.
... View more