I have A DUAL HOME 5k to 2Ks , and would like to configure server ports 8 ports from each 2k.   int ethernet 100/1/1 - 8 int ethernet 101/1/1-8     all 8 ports from each 2k switches are connected to the same switch.   would the following configuration work? on switch 1 and 2. CiscoNexus-1(config-if)# interface ethernet 100/1/1-8 CiscoNexus-1(config-if)# switchport mode trunk CiscoNexus-1(config-if)# switchport trunk native vlan 100 CiscoNexus-1(config-if)# switchport trunk allowed vlan 100-105 CiscoNexus-1(config-if)# channel-group 128 CiscoNexus-1(config-if)# no shutdown CiscoNexus-1(config-if)# exit CiscoNexus-1(config)# interface port-channel 128 CiscoNexus-1(config-if)# vpc 128 CiscoNexus-1(config-if)# no shutdown CiscoNexus-1(config-if)# exit       ... View more

You can do this via GUI or CLI. Here is an example config in CLI. You need to configure correct gateway (should be the IP of your DSL modem IP) & proper DNS server info.  ip dhcp excluded-address 192.168.21.1 192.168.21.10 ! ip dhcp pool VLAN21 network 192.168.21.0 255.255.255.0 default-router 192.168.21.1 dns-server 8.8.8.8 Note that AP cannot do any NAT, so your DSL modem should do this. Ideally you should define DHCP on your DSL modem HTH Rasika *** Pls rate all useful responses *** ... View more

Hello This tool is only for covert a catalyst 6500 from catos to ios . For any other swicht type will the resuls not be really correct. Andy ... View more

Thank you ... View more

I had the same issue with 6.0.1 in vmware 2.0 would fail on the secuity check step and reask for the password..could replicate everytime without file. found that it only passed when I set the install to use an NTP server and the NTP was available.. once the NTP was set it went through no problems.. ** interesting point though.. on the same box cucm 7.0 worked fine with no NTP.. they must have fixed something.. ... View more

"show module" output shows that both the supervisors are up and have passed all the diagnostic tests - so both the supervisors are working fine and in good state. If there is any problem with the module then you would see it in the "show module", "show logging buffer 1023" & "show log". We can also clearly see that the standby supervisor is in redundant hot state, and has synced up with the active. So i dont see any issues with any of the modules. Regards, Ranganath (TAC) ... View more