About b.tahmasebi

b.tahmasebi · 01-11-2022

Hi... I have a vWLC and have 3 Access Points AIR-AP1832I-E-K9 and work in flexconnect mode and every things work fine, upline between APs and switch are trunk and native vlan are same.But after reboot vWLC all of APs not accessible, I should ping the...

b.tahmasebi · 05-14-2016

Hello, I have 2 switches 2960x and 2 SG300-28 I create vtp between my 2960 and every things is okay... And in SG300 create manually vlans exactly like name and ID in 2960 and enable GRVP in SG300, but cannot pass traffic between them, my uplinks are ...

b.tahmasebi · 01-14-2022

Hi, I have NTP in my network and all of them are sync but I checked again and after reboot happened Thank You,

b.tahmasebi · 05-18-2016

Hi... I reset factory and set again... every things works good... Thank You for your Help...

b.tahmasebi · 05-16-2016

Hi, Now, I found my problem, I joined interface 27(uplink to 2960-01) on SG300 to vlan 28 and I can ping it , but just in 2960-01 can ping that vlan, but every 2 switch 2960 are vtp but in 2960-02 can not ping that host in sg300...! sh cdp neig... ...

b.tahmasebi · 05-15-2016

Dear Borgen this info about my ports 2960-01 Name: Gi1/0/28 Switchport: Enabled Administrative Mode: trunk Operational Mode: trunk Administrative Trunking Encapsulation: dot1q Operational Trunking Encapsulation: dot1q Negotiation of Trunking: Off Acc...

b.tahmasebi · 05-15-2016

Dear Friend, I did that (switchport nonegotiate) on every uplinks, can you explain about hardcoded in SG300...? Thanks,

Member Since	‎05-14-2016 02:11 PM
Date Last Visited	‎01-21-2022 09:56 AM
Posts	7

User Statistics

User Activity

After Reboot vWLC Access Points not accessible

Cannot pass Vlan traffic between 2960x and SG300

Re: After Reboot vWLC Access Points not accessible

Hi... I reset factory and set

Hi,

Dear Borgen

Dear Friend,