Darkglasses
Level 1
Level 1
Member since ‎11-10-2012
‎05-07-2020

User Statistics

  • 38 Posts
  • 2 Solutions
  • 45 Helpful votes Given
  • 10 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
20 Replies
1 Accepted Solution
10 Replies
5 Replies
Certifications

User Activity

Hi All,I have a number of ports to be forwarded to an internal server. All works fine until I apply my ZBF config.Anyone able to cast an eye over my config to suggest how I forward a single port from the internet (dialer 0) to a device on vlan 20?i.e...
Folks,I have 2 x Cisco 887VA routers connected to different internet links. They both feed a Cisco 2960 switch with runs my Business and Home Network. I have one network printer which I want to printer from any vllan. At this point I can ping the pri...
Hi folks,I am trying to balance wireless features vs cost to implement a Cisco Wireless solution across my small office and home network. Any guidance would be welcome. The current setup is 2 x Cisco 887VA router providing internet access to a Cisco ...
Hi Folks, I am looking to replace my ASA 5510 with a 5512-x or 5515-x and looking for a little advice to ensure I get the right version to enable future learning/protect my small network. Essentially I have my CCNA R&S and looking to start either my ...
Hi Folks, I have posted my config below for a little advice/suggestions.This is 1 of 2 Cisco 887 routers which feed into a Cisco 2960 switch were I have mapped the access ports to VLANs as below. I have a few questions as I had planned to use Ether C...
Community Statistics
Member Since ‎11-10-2012 04:32 AM
Date Last Visited ‎05-07-2020 12:35 PM
Posts 38
Total Helpful Votes Received 10
Helpful Votes From